Water Heater Strapping Requirements Washington

Water Heater Strapping Requirements Washington

Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with oversized washers.
Place the strapping at the back of the tank. Bring it to the front and then take it back to the wall. several 1/4-inch x 3-inch or longer lag screws with oversized washers. drain spout, and by opening a faucet somewhere in the house.
The minimum capacity for water heaters shall be in accordance with the first hour rating. and bottom door seal and shall meet the requirements of Section 505.1.2.. (4) inches (102 mm) shall be maintained from the controls to the strapping.
Learn about water heater code requirements in Seattle & the East Side.. Earthquake Straps – As you probably know, the state of Washington is at risk of .
and/or Water Heater Strapping requirements, Land Home Financial Services, Inc. (LHFS) requires the. . Washington: All non- primary residence shall install CO .
water heater – provided, of course, that it remains standing. for strapping water heaters because many tanks burst through their. Seattle, WA 98104. 206-233- .
The double-body strap is the system of choice wherever water heater bracing. Idaho, Wyoming, Montana, Oregon, Washington and Hawaii also fall under the. Code (HSC) to require the installation of water heater bracing or strapping on all .

Leave a Reply

Your email address will not be published. Required fields are marked *

© 2018 - We do not claim ownership to any content found on this site. All images are copyright to their respective owners.
top